Taskforce irrigation. To water up to 10 pots automatically. Includes 10 meters of vinyl tubing, a timer that can be programmed to change the frequency and duration of irrigation and an irrigation pump.
- 1 water timer unit (pump included).
- 10 meters vinyl tube (which can be cut to the required length).
- 10 stainless steel tweezers.
It will not operate if the detector is located at the end of the bar is completely submerged in water.
If your computer beeps should replace the batteries or add more water to the tank. To disable these beeps press the "Power" button to turn off the computer, and then press it again to turn on the unit again.
Make sure the connectors are not used with the lid closed. Normally only one tube is required per plant.
IRRIGATION PROGRAMMING EXAMPLE
- Irrigation desired
- 1 once daily
(For 30 seconds)
- 2 times per day
(For 20 seconds)
- Watering every two days
(For 60 seconds)
- Watering once a week 1
Reference table (when the run time is 30 seconds)
- Flow tubes and each tube (ml. / Sec.)
1 -Fill a container with water, insert the rod into the water (as shown in Figure 1, Item 10) and hang the unit on an edge of the container (as shown in Figure 1, Item 1)
2 -Open one of the output caps water irrigation unit and insert a tube in it (see Figure 1 point 8). Note that you may need to trim the end of the tube at a slight angle for proper insertion.
3 -Take the other end of the tube to the pot you want to water, with the help of scissors cut the pipe leaving sufficient length to reach the potting soil (Figure 1 points 6-7). Secure the tube with the clamps.Repeat the same process with few want to water plants. Note that the flow of water will vary depending on the number of tubes which connect to the unit. (Please see the table of references at the end of the instructions).
Important:Once programmed, the unit will operate for an indefinite period of time the water has run out or remove the water system.
1.Unscrew the battery compartment, remove the drive and insert four batteries (not included).
2.Press the "Power" button until the LCD screen the word "day" (see fit and use the "up" or "down" to adjust the frequency of irrigation (from 0.1 30 days). Example: if you want to program the unit to operate 5 times a day, will have to adjust the frequency to 0.2 (1/0.2 = 5). If instead you want the unit 2 times daily watering frequency to be 0.5 days (1 / 0.5 = 2). For more examples see Table irrigation.
3.Press the "Set" button until display flashes the word "Section" and press the "Down" to adjust the run time (from 1 to 99 seconds). Example: if you want to schedule arun time of 20 seconds, simply select 20. On the contrary if you want the run time of 30 seconds will select 30. For more examples see Table irrigation.
4.Press the "Test" for the first irrigation and automatically come into operation as scheduled. If you press the "Power" button first and then press the "Test" will configure the default schedule, watering time is 30 seconds and the frequency will be 0.1 days.